The Standard Tie

When trolling your Tomic Plug, it is very important to place the knot as far back and centered on tow bar as possible.

     

To do this, use a Trilene knot as shown in diagram #1. Notice that leader is threaded through tow bar twice. While holding both loops, proceed as regular cinch knot, use 5-10 wraps. To tighten, pull tag end snug while sliding knot with thumb and forefinger. Repeat this until a tight knot is achieved on pin. This will ensure the knot won't slip from position as in diagram 1a. This position will give your plug the correct side to side swimming action.

If the plug pulls to one side, push the knot in the direction you want the plug to track to correct the action.

An even side-to-side swimming action is best. The plug should not roll and if it does it’s going too fast. If you’d like to go fast, you can change to a bigger hook that will act like a keel and allow a faster troll.